Basically there are 2 types of audio tone control circuits. First one is active tone control circuit and other is passive tone control circuit. An Audio tone control circuit is said to be active if it consists of amplifier. In absence of amplifier, circuit is said to be passive tone control circuit. This article explains you how to design an audio tone control circuit with the gain of around 25. This design needs less number of components and it is cost effective.
Audio Tone Control Circuit Diagram:
Circuit Components:
TL072 Operational amplifier 100k Pot – 3 Audio jack Resistors – 2.2M, 100k(2), 10k(2), 1k(2), Capacitors – 100pF, 1uF, 2.2uF, 22nF(2), 220nF, 2.2nF
Audio Tone Control Circuit Design:
The audio tone control circuit mainly consists of two sections – one is amplifier and other is passive tone control circuit. The amplifier stage consists of TL072 non inverting amplifier. Resistor R3 is connected in between the pins 1 and 2 to provide the feedback to the operational amplifier. Pin2 of op amp is connected to the ground through the resistor R4. Here resistors R3 and R4 are used to set the gain of the operational amplifier. The gain of operational amplifier in non inverting mode is given as Av = 1+ (R3/R4). The input impedance of first stage is approximately equal to the R3. Here C2 capacitor is used as a decoupling capacitor and also used to set the low frequency cut off. Here resistor R2 is used to reduce the offset effect on the operational amplifier output. The value of this resistor should be approximately equal to R3||R2. The tone control section can produce a boost of 20dB. In this section, pot RV1 used to the BASS and other pot is used to control the TREBLE. Pot RV2 is used to control the VOLUME AND Pot RV3 is used to adjust the balance. Resistor R7 provides the isolation between BASS and TREBLE. Circuit Components:
12-0-12V, 500mA center tapped transformer Diode bridge – 1A 680uF Electrolytic capacitors – 2 0.01uF capacitors – 2
This circuit provides +15V and -15V power supply to the audio tone control circuit. Here center tapped transformer is used to step down the voltage. Diode Bridge D1 is made with four 1n4007 diodes. This diode bridge is used to provide pulsating DC from AC voltage. Capacitors are used to filter the AC ripples.
How to Operate Audio Tone Control Circuit:
Audio Tone Control Circuit Advantages:
The circuit uses less components and it is cost effective. The circuit is portable.
Audio Tone Control Circuit Applications:
This audio tone control circuit is used in Audio systems to control the audio tone. Used in music players to control the bandwidth.
This circuit is simulated in software and may require some changes in practical.
Comment * Name * Email * Website
Δ
